[ATM] CouderPrn again

[Tom Stokes]

I've made a few improvements in my Couder mask printing program. One of the
improvements was in getting better accuracy in the printout. You may not
notice this change at all. But then again, I may have broken it. My biggest
headache was in drawing  the right hand edge of the enclosing rectangle of
the useable print area. Please try it and let me know if anything doesn't
look right. e.g. Is the print preview the same as the printout? Just print
one page > 0 for this test. It works on my printer which is a Laser Jet 4 
(600 x 600 dpi).

I have only recently put a link to CouderPrn on my web site. Go here and
look near the bottom of the page.

http://www.mirrorgrindingmachine.com/

Tom Stokes